Need some help. We currently have 8 VLAN's coming in on one interface and they each run their own appletalk zone. I would like to prevent each zone from being seen in the other subnets. Do I need to stop it on the subinterface or in the main router config? Thanks!
Thank you for the reply, it got me started. Here is the problem I am running into now. I want one other zone to be able to see this zone. How do I set that? Is it an in or out apply or both? Here is the current access list:
access-list 601 permit zone RHS
access-list 601 deny additional-zones
access-list 601 permit cable-range 300-310
access-list 601 deny other-access
I would like to be able to see into the RHS zone from the CR zone with cable range 380-390.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...