Recommended Action: The system has corrected the inconsistency. No action is required. If the same prefix gives repeated errors, check the CEF prefix on the RP and line card, and, if required, use the clear cef linecard EXEC command to download a ne w CEF table on the card. If the system is generating a large number of these messages, this message may indicate a software failure in the CEF code. If a software failure in the CEF code has occurred, consider upgrading your system to the latest Cisco IOS software release in your release train to take advantage of recent fixes. If the problem still occurs after the upgrade, copy the error message text exactly as it appears on the console or in the system log, enter the show tech-support, show ip cef, and show log commands, contact your Cisco technical support representative, and provide the representative with the gathered information.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...