07-31-2003 06:54 PM - edited 03-02-2019 09:17 AM
This message is linecard fail,but we plug the line card to another cat6500 is normal.
SYNDIAGS:Syndiags failed on Module #4. Use 'show test 4'
to see results of tests.
Module 4 : 8-port 1000BaseX Ethernet
Line Card Firmware Status for Module 4 : PASS
Port Status :
Ports 1 2 3 4 5 6 7 8
-----------------------------
. . . . . . . .
GBIC Status :
Ports 1 2 3 4 5 6 7 8
-----------------------------
N N N N N N N N
Line Card Diag Status for Module 4 (. = Pass, F = Fail, N = N/A)
Loopback Status [Reported by Module 1] :
Ports 1 2 3 4 5 6 7 8
-----------------------------
F F F F F F F F
07-31-2003 09:14 PM
Check to see if the card is seating properly. Check for any bent pins in the backplane
07-31-2003 09:54 PM
Thanks your help
We check for any bent pins in the backplane then found bent pins in module 3. Now our cat6500 is normal
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide