Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Strange Problem Cat6500

This message is linecard fail,but we plug the line card to another cat6500 is normal.

SYNDIAGS:Syndiags failed on Module #4. Use 'show test 4'

to see results of tests.

Module 4 : 8-port 1000BaseX Ethernet

Line Card Firmware Status for Module 4 : PASS

Port Status :

Ports 1 2 3 4 5 6 7 8

-----------------------------

. . . . . . . .

GBIC Status :

Ports 1 2 3 4 5 6 7 8

-----------------------------

N N N N N N N N

Line Card Diag Status for Module 4 (. = Pass, F = Fail, N = N/A)

Loopback Status [Reported by Module 1] :

Ports 1 2 3 4 5 6 7 8

-----------------------------

F F F F F F F F

2 REPLIES
Cisco Employee

Re: Strange Problem Cat6500

Check to see if the card is seating properly. Check for any bent pins in the backplane

New Member

Re: Strange Problem Cat6500

Thanks your help

We check for any bent pins in the backplane then found bent pins in module 3. Now our cat6500 is normal

132
Views
0
Helpful
2
Replies
CreatePlease to create content