Thinking about putting sub-interfaces on my Cisco 4700 series router running 11.1(20). Ran out of DHCP addresses and was thinking about putting a sub-interface on the FE port of the router. Activate another DHCP scope on the sub-interface so that the users can get either an DHCP address from the main interface subnet or DHCP address from the sub-interface.
I would add 2 sub-interfaces, and take the config from the main FE and put it on the first sub-interface and configure your second network on the other sub-interface and do inter-VLAN routing. (ie, router on a stick)
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...