Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Supervisor Engine Fails on 4506, HELP, tech-support below

Power-On-Self-Test Results for ACTIVE Supervisor

Power-on-self-test for Module 1: WS-X4515

Port/Test Status: (. = Pass, F = Fail)

Port Traffic: L2 Serdes Loopback ...

Port Traffic: L2 Asic Loopback ...

Port Traffic: L3 Asic Loopback ...

0: F 1: F 2: F 3: F 4: F 5: F 6: F 7: F 8: F 9: F 10: F 11: F

12: F 13: F 14: F 15: F 16: F 17: F 18: F 19: F 20: F 21: F 22: F 23: F

24: F 25: F 26: F 27: F 28: F 29: F 30: F 31: F audit: F

Switch Subsystem Memory ...

1: . 2: . 3: . 4: . 5: . 6: . 7: . 8: . 9: . 10: . 11: . 12: .

13: . 14: . 15: . 16: . 17: . 18: . 19: . 20: . 21: . 22: . 23: . 24: .

25: . 26: . 27: . 28: . 29: . 30: . 31: . 32: . 33: . 34: . 35: . 36: .

37: . 38: . 39: . 40: . 41: . 42: . 43: . 44: . 45: . 46: . 47: . 48: .

49: . 50: . 51: . 52: . 53: . 54: . 55: .

Module 1 Failed

2 REPLIES
Cisco Employee

Re: Supervisor Engine Fails on 4506, HELP, tech-support below

Can you power cycle the switch once? Turn off all the power supplies and turn them back on. Also make sure it is seated fully and screws tightened. You can reseat it firmly to make sure

New Member

Re: Supervisor Engine Fails on 4506, HELP, tech-support below

I had contact with a Cisco Engineer, the Supervisor Engine had a hardware failure.

134
Views
0
Helpful
2
Replies
CreatePlease to create content