02-13-2004 12:00 AM - edited 03-02-2019 01:34 PM
I have two Catalyst 4507R with two Supervisor 4 installed for each.
To use both giga ports on board (in practice to connected this switch in channel with four links hence giga 1/1,1/2,2/1,2/2 available)
How have to I configure Supervisors ?
Thanks
Lorenzo
02-13-2004 12:33 AM
please read "command reference guide" and "configuration guide".
http://www.cisco.com/univercd/cc/td/doc/product/lan/cat4000/12_1_20/index.htm
02-13-2004 12:58 AM
Ok,
but Can I disable RPR from Supervisor 4?
What's happen if I do it ?
Thanks
Lorenzo
02-13-2004 01:08 AM
You would have to. I don't know what is more important to you....redundancy or more Gig ports? Please read this document.
http://www.cisco.com/univercd/cc/td/doc/product/lan/cat4000/12_1_20/config/rpr.htm
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: