Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Supervisor mod on a Cat 4506

On Cat 4506 with slots 5 and 6 open, can I put a supervisor module in on of those slots and with out interfering with the sup. mod. in slot 1 and the check the software ver. on the sup. mod in either slots 5 or 6?

2 REPLIES
Bronze

Re: Supervisor mod on a Cat 4506

A catalyst 4500 supIV ( ws-x4515 ) or ws-x4013+ goes only into slot1 or slot 2.

Read the guidelines and restrictions about putting 2 sups in the same chassis before considering about placing another sup in the chassis. See the URL below for that guide.

Reference:

URL: http://www.cisco.com/univercd/cc/td/doc/product/lan/cat4000/12_1_20/config/rpr.htm#1097897

Cisco Employee

Re: Supervisor mod on a Cat 4506

Since you have a 4506, redundant Sup is not supported. You need a 4507 for redundant Sup support. Also, Sup would go into Slot 1 and/or 2

107
Views
0
Helpful
2
Replies