Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Suspending a telnet session using MINICOM (Ctrl+Shif+6,x)???

Hello,

I'm using Linux machines to configure Cisco routers, then I use MINICOM to do this... so... when I try to suspend a telnet session using Ctrl+Shif+6, x.... the minicom don't understand this sequence.... I tried to change the terminal emulation to ANSI, etc... but without sucess....

How can I suspend a telnet session on MINICOM???

Are there another good terminal emulation software to use on LINUX???

Thanks...

Jefferson

2 REPLIES
Bronze

Re: Suspending a telnet session using MINICOM (Ctrl+Shif+6,x)???

Not sure about minicom, but many terminal software use Ctrl+6 instead of Ctro_Shift+6. Try Ctrl+6, x.

Ming

New Member

Re: Suspending a telnet session using MINICOM (Ctrl+Shif+6,x)???

Hello Ming....

Your help is very helpfull.....

Thanks...

488
Views
1
Helpful
2
Replies