Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

Bronze

svi

Hey guys,

When you have a 650x with the ports in different vlans and you want to route between the vlans using the msfc on the supervisor engine, do you just make interface vlan1, vlan2, etc?

Thanks

1 REPLY
New Member

Re: svi

That is correct. Configure as if you are connecting an interface for each vlan from the MSFC to the switch....

configure routing as you would on a router;

Router(config)# ip routing

Router(config)# router eigrp 10

Router(config-router)# network 10.0.0.0

Router(config-router)# network 20.0.0.0

and an interface for each vlan;

Router(config-router)# interface vlan 100

Router(config-if)# ip address 10.1.1.1 255.0.0.0

Router(config-router)# interface vlan 200

Router(config-if)# ip address 20.1.1.1 255.0.0.0

etc....

best of luck !

90
Views
0
Helpful
1
Replies