Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Switch Catalyst 4506

Hello,

I have one Catalyst 4506 with Supervisor 4.

My Catalyst 4506 is the default gateway for all my PC (Supervisor 4 L3 using OSPF routing protocol).

I want to implement HSRP to have redundant gateway. For this action i will buy a second CATALYST 4506 installed with a Supervisor 4 module.

1) Is this configuration OK ?

2) HSRP with OSPF is it OK ?

3) How can i know the delay for the convergence if one catalyst 4506 is not responding.

Thanks for your help

1 REPLY
New Member

Re: Switch Catalyst 4506

It depends how your access layer is connected to the cat4506 switches.

HSRP it's ok with OSPF and the delay is configured with preempt delay and hello timers in HSRP configuration.

You can find more information about HSRP in the following URL:

http://www.cisco.com/univercd/cc/td/doc/product/software/ios121/121cgcr/ip_c/ipcprt1/1cdip.htm#wp1001531

228
Views
0
Helpful
1
Replies