Got my 2621 switch up and running and started having trouble with my T1 at about the same time I put the switch in. I think the T1 is fixed but the switch is getting errors on the port the router is plugged in to. The data on the port looks like this:
5 minute output rate 192000 bits/sec, 185 packets/sec
114254 packets input, 59196041 bytes, 0 no buffer
Received 531 broadcasts, 0 runts, 0 giants, 0 throttles
3023 input errors, 0 CRC, 731 frame, 0 overrun, 4 ignored, 0 abort
0 watchdog, 11 multicast
0 input packets with dribble condition detected
92194 packets output, 12250155 bytes, 0 underruns
0 output errors, 1896 collisions, 5 interface resets
0 babbles, 0 late collision, 7516 deferred
0 lost carrier, 0 no carrier
0 output buffer failures, 0 output buffers swapped out
As you can see there are both frame errors and collisions. I have the keepalive set to 10. Should that be set at all? There is no other port-specific parameter set. Should there be? Any help greatly appreciated!
Pat
