This is a very old thread to try to re-start. You probably would be better off to start a new thread and ask your question as a fresh issue.
In the context of the original post FW is FirmWare. We do not have enough information to give a good answer about fw and fw1. My guess is that there are two different modules/cards each with its own firmware but the display in the original post only contained the slot port model information for the slot with supervisor.
If you have a similar situation then perhaps you could post the output of show module from your switch? If we had a more complete output we might be able to give better answers.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...