Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Switch port: Link & Line protocol up/down

Hi all

I need expert advice from all of you.

Please see that attchment for details.

Many thanks in advance

ATU

8 REPLIES

Re: Switch port: Link & Line protocol up/down

Hi!

Was it working fine before??? Can you paste the output of 'Show run int fa 0/13' here?? Is the server 'teamed'??

Regards,

AbhisheK

New Member

Re: Switch port: Link & Line protocol up/down

Hi AbhisheK

Thanks for the reply.

Yes It was OK until recently (~a week ago).

As requested:

SW032_C29L01A09#sh run interf fa0/13

Building configuration...

Current configuration : 99 bytes

!

interface FastEthernet0/13

switchport access vlan 2

no ip address

spanning-tree portfast

end

SW032_C29L01A09#

The server is not teamed.

Thanks & regards

Re: Switch port: Link & Line protocol up/down

HI Tutinco,

its not the probs with the switch, it could be the probs with the cable termination, juz re-terminate them either on the Information Outlet or on the jack panel end. also try changing the patch cord

hope this helps,

rate this post.

New Member

Re: Switch port: Link & Line protocol up/down

Hi

Thanks for the advice. I will check it all and let you know shortly.

Regards

Bronze

Re: Switch port: Link & Line protocol up/down

Hi.

Few things need to be check

1) cable termination RJ45

2) check other end of cable/switch

3) check speed setting

4)

It looks like physical layer problem..

_Minu

New Member

Re: Switch port: Link & Line protocol up/down

Thanks Minu

I will check them all.

Regards

Re: Switch port: Link & Line protocol up/down

Hello,

you might want to try, as suggested previously, to set the switchport to:

duplex full

speed 100

and make sure that the settings on the server NIC match, that is, that the server NIC is not configured for auto-negotiation...

Regards,

GNT

New Member

Re: Switch port: Link & Line protocol up/down

Thanks GNT

I will try this.

Regards

267
Views
8
Helpful
8
Replies