Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

switch-switch giga uplink failed

two WS-C2950T-24 switches connected thru their g0/2 ports , the link is inactive; changing any one side to fast eth restores the connectivity and both g0/2 are functional in at 100mbps. POST detects all h/w as OK. The g0/1 of the switch is connected to another identical switch in a similar fashion and is working fine.

IOS ver of both switches are :IOS (tm) C2950 Software (C2950-I6Q4L2-M), Version 12.1(11)EA1, RELEASE SOFTWARE (fc1). The link was functional earlier. Incident to note was a lightning strike on a nearby building after which the failure was noticed. The switches are powered thru online UPS.

pls let me know how the issue can be resolved.

pls revert at my mail id : kthyagarajan@wipro.co.in

  • Other Network Infrastructure Subjects
1 REPLY
Bronze

Re: switch-switch giga uplink failed

If there is some damaged caused to the hardware due to lightning, I think you diagnose the problem only by doing RMA of the failed unit.

Just to confirm that it is a hardware failure, you may want to swap the devices with the same configs.

78
Views
0
Helpful
1
Replies
This widget could not be displayed.