Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

switch Switch1(config)#switching-type

Does anyone know how to configure-retreive these settings for a 3560 POE switch?

I would like to be able to configure individual ports to cut-through, fragment-free etc...

Switch1(config)#switching-type ?

fragment-free Fragment Free mode

store-and-forward Store-and-Forward mode

Switch1(config)#switching-type store-and-forward

3 REPLIES
Silver

Re: switch Switch1(config)#switching-type

I think there is no such option in 3560 switch to configure the ports with different switching option.

The best way is to configure all the ports in the switch to a single switching option.

New Member

Re: switch Switch1(config)#switching-type

I read somewhere that this could be done on a per port basis somewhere - but I could be wrong. I know on the 1900, you can set the entire switch.

Re: switch Switch1(config)#switching-type

Hi,

This is a global configuration for the switch and it effects the whole switch. This cannot be done on per port basis.

HTH, Please rate if it does.

-amit singh

147
Views
0
Helpful
3
Replies
CreatePlease to create content