We are budgeting an upgrade for our network - cisco 2940/2950 for the switch closets and (2) 4506 core(s)). The issue we are facing now is trying to decide which uplink cabling to invest in - fibre or cable. Right now, it would be $15k more if we do fibre. I would appreciate any input you could offer in helping me justify th 15k cost.
If you can run cable and keep it within specs using cat 6 cable then I wouldn't spend an extra 15000 just to have fiber as long as you don't have to run the cable thru high interference areas like factory floors etc...
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...