Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Switch Utilization on 2900 and 3500 Switches

Hi,

I am trying to automate the process of getting Switch Utilization for 2900 and 3500 Switches and plot them using MRTG.

The command that i am using is

"show controller switch", which gives me the required info Total BW,Total BW Limit, Peak BW and Thresholds.

Is there a MIB OID(s) for these parameters that i can poll to get the needed values ?

If not, then how can i automate this process and plot graphs ?

I would prefer not to use the Cisco Cluster Manager.

1 REPLY
Bronze

Re: Switch Utilization on 2900 and 3500 Switches

The following link gives the MIB and OID for all products.

http://www.cisco.com/public/sw-center/netmgmt/cmtk/mibs.shtml

88
Views
0
Helpful
1
Replies