Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Switches keep appearing as stacks in CW even when a single unit

I have been trying with little success to reset the switch identity type in CiscoWorks from a "Cisco 3750 Stack" to a "Cisco 3750-24ts". Every time it is modified, after a few seconds the type switches back to the "stack" type. I have even tried removing the device(s) and re-adding them to CW but the same thing occurs. The unit is in fact not a stack but a single switch unit. Is this behavior being caused from the unit's IOS? ((C3750-IPBASE-M), Version 12.2(25)SEB1) or is there a configuration item that I have missed that should allow it to appear as a single unit to CW?

  • Other Network Infrastructure Subjects
2 REPLIES
Cisco Employee

Re: Switches keep appearing as stacks in CW even when a single u

You might want to post this in the Network Management Forum

New Member

Re: Switches keep appearing as stacks in CW even when a single u

In the configuration of the switch do you have switch 2 provision (switch). Perhaps it was stacked at one point and you will have to get rid of the statement of switch 2 in the configurations.

128
Views
0
Helpful
2
Replies
This widget could not be displayed.