I have a new scenario that is coming up. We are currently using point to point T1s between remote offices and our centralized data center.
We will be adding a metro ethernet that will be switched; however, we wish to keep the T1s as a fail over in case the service provider's ethernet switching is down. Any ideas on how I could configure this?
Well, if you keep all the sites as their own subnet, you could potentially route between them. The real question is how does your provider give you access between your sites? Are they all on the same layer 2 domain, or do you get them as VLAN's or what?
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.