It seems like you have 3 FE interfaces connected to the 3640, on 0/0 you have one 3548 connected and other3x 3548 you have workstations connected..
You also mentioned that the 3 3548s are connected to the server switch which is on differernt subnet.. What is the reason of connecting server switch to the workstations switches. Since these are two different subnets, this is not a good idea to connect the server switch to the workstation switches,
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...