Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

switchport configuration on 6509 with Native code

i am unable to configure switchport commands such as a trunk or access port. I get a message that switchport not supported. Has anyone seen this and how do I get around it.

1 REPLY
Cisco Employee

Re: switchport configuration on 6509 with Native code

By default it's a routed port. Make it a switchport by typing "switchport". Here is an example

LS-6506-4A(config)#int fastEthernet 5/1

LS-6506-4A(config-if)#switchport access vlan 10

Command rejected: Fa5/1 not a switching port.

LS-6506-4A(config-if)#switchport

LS-6506-4A(config-if)#switchport access vlan 10

LS-6506-4A(config-if)#

388
Views
0
Helpful
1
Replies
CreatePlease to create content