Synchronizasion time between Cisco2520 and Windows2000 Domain Controller.
I would like to configure Cisco2520 as NTP time server of my domain and need the Domain Controller to sync time with cisco2520. Please somebody give me the link to information related to this issue. Any advice, tips would be greatly appreciated. Thank in advance.
But there are some problems. 2500 Router isn't save time after reload, so in case of any reboot or power shootdown your network time will be set to Year 1993. It is not a good idea to use router as time source.
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...