Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

SYS-5-REDUNDANTCLOCK_FAIL: Redundant clock failed

on 6509 i am getting this message " SYS-5-REDUNDANTCLOCK_FAIL: Redundant clock failed" everytime,please explain and sugest for it.

3 REPLIES
Silver

Re: SYS-5-REDUNDANTCLOCK_FAIL: Redundant clock failed

SYS-5-REDUNDANTCLOCK_FAIL: Redundant clock failed

Explanation This message indicates that the redundant (standby) clock has failed. Clock switchover from the primary clock to the standby clock is prevented.

This is more than likely coming from your secondary Supervisor. can you reset this to see if this clears? If not, your supervisor, if in a fault state, might be bad.

Hope this helps,

Don

Cisco Employee

Re: SYS-5-REDUNDANTCLOCK_FAIL: Redundant clock failed

Do show env all and see the secondary clock is showing failure.. Seems like the secondary clock on the chassis is failing.. There are two clock modules on the chassis and one is totally redundant so you are ok for now till the primary clock fail :)

open up the tac case to get the replacement for the clock.

New Member

Re: SYS-5-REDUNDANTCLOCK_FAIL: Redundant clock failed

it is also showing this " %SYS-5-REDUNDANTCLOCK_OK: Redundant clock recovered"and again below showing its failed.

251
Views
0
Helpful
3
Replies