This message indicates an error for a specified port. The module detected a payload CRC error in the QChip ASIC. This is a debugging message for Cisco development purposes. The first [dec] is the module
number and the second [dec] is the front panel port.
This message can appear when the card is not seated correctly or there is a hardware failure in the card, but it may also appear as a consequence of a software bug. The message appears related only to module 9, so what I would do is:
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...