Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

You may experience some slow load times, errors, and slight inconsistencies. We ask for your patience as we finalize the launch. Thank you.

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started.

New Member

Syslog events when specific Catalyst Ports fail

Is it possible to configure a Catalyst

(5xxx or 29xx) for sending syslog

messages if a specific ethernet port

goes down. Currently i receive a message

for every port which changes the status.

This is not interesting if a

workstation is connected to this port, but will be interesting if a server is

connected.

  • Other Network Infrastructure Subjects
1 REPLY
Anonymous
N/A

Re: Syslog events when specific Catalyst Ports fail

On a CatOS based switch, you can use 'set port trap X/Y disable' to knock out traps for ports you consider uninteresting. For IOS-based switches, the equivalent is "no snmp trap link-status".

185
Views
0
Helpful
1
Replies