i am trying to turn logging on to an older 3500 switch running 12.0 ios. i found the following best practices for the 4000 series, does anyone have best practices for logging on a 3500, i am trying to avoid wasting unecessary resources while its in production.
Most of these commands are not available on XLs running 12.0 code. Default logging should be sufficient. Just make sure you have a server which is set for syslogging and point the switch to the server.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...