Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

System information in Catalyst 4006 with sup engine III with IOS 12.1(EW)

Hello,

I was wondering whether we can see system information like chassis properties like environment, modules present and configured interfaces in one command.

Would there be a event logging mechanism for later viewing like access to the system via telnet with timestamps or any error conditions for example.

I appreciate the thoughts.

6 REPLIES
Cisco Employee

Re: System information in Catalyst 4006 with sup engine III with

Will a "sh tech" help?

New Member

Re: System information in Catalyst 4006 with sup engine III with

Yes.

show env

show mod

show run or show interface status

you can enable event logging via the usual IOS sysloging configuration.

New Member

Re: System information in Catalyst 4006 with sup engine III with

Thanks for the help. I think "sh tech" is not a valid command in IOS and also sh run and this may work probably in catos. But we are migrating from Nortel to Cisco at the core and have bought these new line of switches with native IOS and never worked with cisco before. sh env and sh mod works fine. I need to readup the documentation has how to setup syslog to setup event logging. Thanks for all the help. Actually sh tech and sh config works in Nortel Passport series switches which brings up everything from module to configurations like sysup time, what revision of code the module is and is a good diagnostic tool. I appreciate the quick response. Thanks.

Cisco Employee

Re: System information in Catalyst 4006 with sup engine III with

sh tech is a valid command in IOS. You need to be in enable mode

Switch#show tech-support

New Member

Re: System information in Catalyst 4006 with sup engine III with

I strongly suggest that you read the documentation and use the command reference below

http://www.cisco.com/univercd/cc/td/doc/product/lan/cat4000/12_1_11/index.htm

New Member

Re: System information in Catalyst 4006 with sup engine III with

I am thankful for enlightening me about these commands. I am sorry that I didn't specify in which mode I was when the command didn't work. Good learning experience. Thanks.

158
Views
0
Helpful
6
Replies
CreatePlease to create content