I have a 1605-R, that when powered on the System OK light on the front panel keeps blinking, normally indicating the boot process. I let it go for 15 minutes just to be sure it dosen't eventually end up booting properly.
I can't get access to the console port either, perhaps related to the same issue?
Regarding you not able to console in, are you able to console into any other cisco device with the same cable/pc? I want to make sure the cable/console settings are good. If so, and you see nothing on the 1605 console, try sending a break after you reboot the router. If you are able to break into rommon, try a manual boot
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...