Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

System returned to ROM by power-on

Hi

One of our 7206 have problems with self-boot. Some says that the message system returned to ROM by power-on means that someone have physically booted the router or the we've had loss of power. Is this true or can there be other explanations for the outline in sh version? The sh log shows this msg: No More free buffer in vnm_dsprm_free_msg_Q

00:00:20: vnm_dsprm_line_status_from_port: failed on 5 card

1 REPLY

Re: System returned to ROM by power-on

Often times complex troubleshooting issues are best addressed in an interactive session with one of our trained technical assistance engineers. While other forum users may be able to help, it’s often difficult to do so for this type of issue.

To utilize the resources at our Technical Assistance Center, please visit http://www.cisco.com/tac and to open a case with one of our TAC engineers, visit http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

412
Views
0
Helpful
1
Replies
CreatePlease login to create content