System Software change from IOS to CATOS on 2948G l3 switch
Have been trying to change a 2948G switch from IOS to CATOS. As of yet have found nothing on CCO for the correct procedure. Have tried doing a promupgrade in preparation for putting 6.4(7)(cat 4000 image) on the switch but to no avail. Any of you guys seen any literature of the correct procedure here or come across this before? Thanks in advance....Ross.
PS the current state of the switch is that it is in ROMMON.
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...