Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

T1 Errors Threshold

Is it possible to set a T1 interface threshold or T1 controller threshold to shutdown the interface when threshold has been exceeded?

I've got a flaky T1 that regularly takes major hits, but apparently enough data gets through to keep the T1 up. When this happens my systems passing traffic are delayed in the data exchange.

1 REPLY
Bronze

Re: T1 Errors Threshold

I think if you can associate a T1 interface to a dialer you can set a threshold limit, but not sure whether you make it shut down.

136
Views
0
Helpful
1
Replies
CreatePlease to create content