Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

T1 PPP Multilink

Does this look like a good generic T1 Multilink Config?

interface Multilink1

ip address 192.168.10.10 255.255.255.0

no cdp enable

ppp multilink

multilink-group 1

!

interface Serial0/0

description T1 circuit ID etc..

bandwidth 1536

no ip address

no ip redirects

no ip unreachables

no ip proxy-arp

ip accounting access-violations

encapsulation ppp

no ip mroute-cache

no fair-queue

service-module t1 timeslots 1-24

service-module t1 remote-alarm-enable

no cdp enable

ppp multilink

multilink-group 1

!

interface Serial0/1

description T1 circuit ID etc.

bandwidth 1536

no ip address

no ip redirects

no ip unreachables

no ip proxy-arp

ip accounting output-packets

ip accounting access-violations

encapsulation ppp

no ip mroute-cache

keepalive 5

no fair-queue

service-module t1 timeslots 1-24

service-module t1 remote-alarm-enable

no cdp enable

ppp multilink

multilink-group 1

  • Other Network Infrastructure Subjects
1 REPLY
Cisco Employee

Re: T1 PPP Multilink

The config looks fine..Here is the link which explains how to bundle and troubleshoot more then one T1 link using interface multilink command.

http://www.cisco.com/univercd/cc/td/doc/product/aggr/10000/10ksw/mlppos.htm

Remove un-required commands if you don't need.

327
Views
0
Helpful
1
Replies
This widget could not be displayed.