04-16-2004 09:49 AM - edited 03-02-2019 03:03 PM
Have a problem with controller T3 on 7505
IOS level 12.2.7a
trying to configured as
'no channelized'.
so :
TORRTER02(config)#controller t3 6/1/0
TORRTER02(config-controller)#no ?
cablelength cable length in feet (0-450)
clock Specify the clock source for a T3 link
description Controller specific description
equipment Specify the equipment type for loopback mode
framing Specify the type of Framing on a T3 link
idle Specify the idle pattern for all channels on a T3 interface
loopback Put the entire T3 line into loopback
mdl Maintenance Data Link Configuration
mode Configure the controller mode
shutdown Shut down a DS3 link (send DS3 Idle)
t1 Create a T1 channel
There is no "channelized" option
Am I wrong ? Without this I can not see
Serial 6/1/0
Please help
Regards
Sladjan
04-16-2004 01:13 PM
Hi,
try just entering 'no channelized.' I have seen the 7500 series platform take commands even though they do not show up as an option. Or it may just be a code quirk, but it should still take it.
04-18-2004 04:40 PM
Hi Sladjan,
Can you please post the 'show diag' of your 7505 router or let me know what T3 port adapter are you using on your router for me to verify if this is normal or not, thank you.
Best Regards,
Ansley R. Verzosa
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide