Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

T3 no channelized

Have a problem with controller T3 on 7505

IOS level 12.2.7a

trying to configured as

'no channelized'.

so :

TORRTER02(config)#controller t3 6/1/0

TORRTER02(config-controller)#no ?

cablelength cable length in feet (0-450)

clock Specify the clock source for a T3 link

description Controller specific description

equipment Specify the equipment type for loopback mode

framing Specify the type of Framing on a T3 link

idle Specify the idle pattern for all channels on a T3 interface

loopback Put the entire T3 line into loopback

mdl Maintenance Data Link Configuration

mode Configure the controller mode

shutdown Shut down a DS3 link (send DS3 Idle)

t1 Create a T1 channel

There is no "channelized" option

Am I wrong ? Without this I can not see

Serial 6/1/0

Please help

Regards

Sladjan

2 REPLIES
New Member

Re: T3 no channelized

Hi,

try just entering 'no channelized.' I have seen the 7500 series platform take commands even though they do not show up as an option. Or it may just be a code quirk, but it should still take it.

New Member

Re: T3 no channelized

Hi Sladjan,

Can you please post the 'show diag' of your 7505 router or let me know what T3 port adapter are you using on your router for me to verify if this is normal or not, thank you.

Best Regards,

Ansley R. Verzosa

242
Views
0
Helpful
2
Replies
CreatePlease to create content