Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

TA not accecpt incomming calls

I have installed TA (External Modem ISDN US-Robotics) for incomming calls on my Router 2621 on Wic2t (smart Serial).

The problem is that incomming could not connect, I have debug the modem and the results is as follows,,,

kiit#debug modem

Modem control/process activation debugging is on

kiit#

1d02h: TTY1: DSR came up

1d02h: tty1: Modem: IDLE->(unknown)

1d02h: TTY1: EXEC creation

1d02h: TTY1: create timer type 0, 14380 seconds

1d02h: TTY1: create timer type 1, 1800 seconds

1d02h: TTY1: DSR was dropped

1d02h: TTY1: Quickly dropping DTR

1d02h: tty1: Modem: READY->HASPROC

1d02h: TTY1: Line reset by "Exec"

1d02h: TTY1: Modem: HASPROC->HANGUP

1d02h: TTY1: destroy timer type 0 (OK)

1d02h: TTY1: destroy timer type 1 (OK)

1d02h: TTY1: destroy timer type 3

1d02h: TTY1: destroy timer type 4

1d02h: TTY1: destroy timer type 2

1d02h: TTY1: dropping DTR, hanging up

1d02h: tty1: Modem: HANGUP->IDLE

1d02h: TTY1: restoring DTR

kiit#

kiit#

Could any one tell what is the problem, Thanks in advance......

2 REPLIES
Bronze

Re: TA not accecpt incomming calls

Hard to say; you should always have msec timestamps enabled, first of all:

service timestamp debug date msec

service timestamp log date msec

Next, the config would be useful to see; debug ppp negotiate would be good, too.

New Member

Re: TA not accecpt incomming calls

I have the same problem (with EXEC only) with WIC-2A/S on 2611.

This problem is absent on DB-60 interfaceses (NM-4A/S).

any comments ?

98
Views
0
Helpful
2
Replies
CreatePlease login to create content