Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Tacacs+/Ciscosecure and ISDN

Could someone tell me what is the difference between a dial-up user and an ISDN backup locations set up to authenticate with Ciscosecure through a Tacacs+ server? All the dial-ins and ISDN are set up the same(problem) dial ins are ok ISDN fails. Using Chap and have secret passwords same, host and remote names are opposite etc. Any Ideas?

1 REPLY
Bronze

Re: Tacacs+/Ciscosecure and ISDN

Your config needs to be looked at before going into debugging level, specially the config of the

dialer interface (s) to which the backup location(s) dial. You might want to open up a TAC case too.

~Zulfi

113
Views
0
Helpful
1
Replies
CreatePlease to create content