tacacs+ on cisco 2948

[mgriffin3]

I'm having a trouble with configuring tacacs+ on a cisco 2948 switch. We have added the following config, but when logging in to the switch, you are still prompted with the Username: prompt. If this login fails it will then go to tacacs. Any ideas what I am missing?

#tacacs+

set tacacs server x.x.x.x primary

set tacacs server y.y.y.y

set tacacs server z.z.z.z

set tacacs key xxxxxxx

!

#authentication

set authentication login tacacs enable console primary

set authentication login tacacs enable telnet primary

set authentication login tacacs enable http primary

set authentication enable tacacs enable console primary

set authentication enable tacacs enable telnet primary

set authentication enable tacacs enable http primary

thanks,

Mark

[deilert]

this is correct if you are using tacacs it will prompt you for your username then password or passcode