I'm having a trouble with configuring tacacs+ on a cisco 2948 switch. We have added the following config, but when logging in to the switch, you are still prompted with the Username: prompt. If this login fails it will then go to tacacs. Any ideas what I am missing?
set tacacs server x.x.x.x primary
set tacacs server y.y.y.y
set tacacs server z.z.z.z
set tacacs key xxxxxxx
set authentication login tacacs enable console primary
set authentication login tacacs enable telnet primary
set authentication login tacacs enable http primary
set authentication enable tacacs enable console primary
set authentication enable tacacs enable telnet primary
set authentication enable tacacs enable http primary
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...