Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

tagging and un-tagging VLAN command

Hello All,

I want to configure tagging VLAN 100 across the trunk link and un-tagging VLAN 200 (I think it is a native VLAN) across the same trunk link. Which is the correctly command?

switchport trunk allowed vlan 100,200

switchport trunk native vlan 200

or

switchport trunk allowed vlan 100

switchport trunk native vlan 200

Thanks a lot,

Nitass

1 ACCEPTED SOLUTION

Accepted Solutions
Silver

Re: tagging and un-tagging VLAN command

The first set of the command is the correct command.

switchport trunk allowed vlan 100,200

switchport trunk native vlan 200

Onc you have configured this , please run the command show interface trunk to make sure both vlans 100 and 200 are in spanning-tree forwarding state and not pruned.

Hope this helps.

thanks

Salman Z.

1 REPLY
Silver

Re: tagging and un-tagging VLAN command

The first set of the command is the correct command.

switchport trunk allowed vlan 100,200

switchport trunk native vlan 200

Onc you have configured this , please run the command show interface trunk to make sure both vlans 100 and 200 are in spanning-tree forwarding state and not pruned.

Hope this helps.

thanks

Salman Z.

181
Views
0
Helpful
1
Replies
CreatePlease login to create content