Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

telnet/ping

I just setup a 3550 and am trying to be able to telnet into it. I read the online documentation and setup the vlan1 with an ip address and default gateway. Now, I can't ping it or telnet into it. Is this the correct place to assign the ip address that I can telnet into?

3 REPLIES
Cisco Employee

Re: telnet/ping

is the VLAN interface up/up? From which device are you trying to ping/telnet from? If it's a PC on the same switch, is it in VLAN 1 as well?

Bronze

Re: telnet/ping

Basically from scratch, you can do:

Would you like to enter the initial configuration dialog? [yes/no]: no

Switch>enable

Switch#conf t

Switch(config)#int vlan 1

Switch(config-if)#ip add 10.0.0.1 255.0.0.0

Switch(config-if)#no shut

Switch(config-if)#end

Switch#

Switch#show ip int brief

Interface IP-Address OK? Method Status Protocol

Vlan1 192.168.1.1 YES manual up up

*check for the status of VLAN 1, then start the ping test.

HTH.

New Member

Re: telnet/ping

THANK YOU!!!!! I did not have the vlan up.

127
Views
0
Helpful
3
Replies