Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

TELNET

I am accessing the switch through 3 steps as follow:

TELNET switch name (or IP address), Enter Login ID and Enter Password.

How can do the 3 steps in 1? Is there any specific parameters where you can add the Login ID and password next to the switch name?

If not, is there any other command allow this?

Thank you.

1 REPLY
Bronze

Re: TELNET

It depend on what telnet client you are using. The solaris one allows you to specify the login id but not the password. Most windows based telnet clients will allow you to set up permenant entries with both user and password.

The IOS telnet command however does not have either of these as an option.

174
Views
0
Helpful
1
Replies