Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Terminal Server; how to send string based on a character?

I have connected a pair of scales to a 2511 terminal server. This device constantly generates a string (the weight; " x.xxx g" ). I want the router to send the TCP/IP packet only when a specific character is received (cr or "g"). How do I configure this on my async interface (line)?

1 REPLY

Re: Terminal Server; how to send string based on a character?

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

220
Views
0
Helpful
1
Replies