Firstly, apologies if the answer to this question is startlingly obvious ! -
I have 2 x 2501's and 1 x 2522 setup in a lab. I have connected the first 2501 to the Serial0 interface on the 2522, and connected the second 2501 to the Serial1 interface on the 2522. I have connected the DCE end of the DB60 connectors to the 2501's.
I hav assigned all the IP addresses to the serial interfaces and configured encapsulation as HDLC. I have also enable RIP on all deves, but I can seem to get the routers to see each other through just the Serial interfaces - does anybody have any ideas ?
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...