10-09-2003 11:55 AM - edited 03-02-2019 10:54 AM
I have a quick question; I configured two routers with a T1 connection that will be used for Point-to-point connection. I would like to know how to test this T1 connection since the two routers are in the same location?
Here is a snapshot of the two serials config for the two routers:
Router1
interface Serial3/0
bandwidth 1536
ip address 10.120.14.1 255.255.255.0
encapsulation frame-relay
no ip route-cache
no ip mroute-cache
!
Router2
interface Serial0/0
bandwidth 1536
ip address 10.120.14.2 255.255.255.0
encapsulation frame-relay
no fair-queue
!
The two serial interfaces are connected using a Cable where 1--4 and 2--5
10-09-2003 01:07 PM
use encapsulation hdlc. make sure you set one side to provide the clock.
10-09-2003 06:20 PM
OR, configure the following command at either ends.
frame-relay interface-dlci 100 (for ex)..
and
clock rate
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide