Testing a T1 Point to Point Connection between 2 routers
I have a quick question; I configured two routers with a T1 connection that will be used for Point-to-point connection. I would like to know how to test this T1 connection since the two routers are in the same location?
Here is a snapshot of the two serials config for the two routers:
ip address 10.120.14.1 255.255.255.0
no ip route-cache
no ip mroute-cache
ip address 10.120.14.2 255.255.255.0
The two serial interfaces are connected using a Cable where 1--4 and 2--5
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.