Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

TFTP access

I reconfigured a switch and it is working fine now. I changed the ip address and default gateway and now I can not ping or telnet the switch from anywhere.

Any thought on troubleshooting this??

My other question is this - how do I upload a new startup-config file to my catalyst 3548 switch through hyperterminal while connected to the console port????

Thank you

1 REPLY
Community Member

Re: TFTP access

Is the ip address being used somewhere else ? Does the ARP entry point to the right mac-address. Can you initiate the ping from the switch first ? If you are pinging from the same subnet make sure the ARP is getting correctly populated.

If you can reach the tftp server then you can use the copy tftp: start or copy tftp: run command .

if not you have to use "cut and paste" :)

115
Views
0
Helpful
1
Replies
CreatePlease to create content