Hi All
My customer is running IOS ver 12.2 on his 2620 for Internet Connection with WIC-2T installed. The ISP has given them 2Mbps leased line. The following has configured on the serial interface:
interface Serial0/0
bandwidth 2048
ip address 210.187.59.54 255.255.255.252
ip access-group 100 out
no ip mroute-cache
Following is the show interface results:
ISP2620#sh interfaces serial 0/0
Serial0/0 is up, line protocol is up
Hardware is PowerQUICC Serial
Internet address is 210.187.59.54/30
MTU 1500 bytes, BW 2048 Kbit, DLY 20000 usec,
reliability 255/255, txload 149/255, rxload 144/255
Encapsulation HDLC, loopback not set
Keepalive set (10 sec)
Last input 00:00:00, output 00:00:00, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/17/0 (size/max/drops/flushes); Total output drops: 1415
Queueing strategy: weighted fair
Output queue: 2/1000/64/1415 (size/max total/threshold/drops)
Conversations 0/32/256 (active/max active/max total)
Reserved Conversations 0/0 (allocated/max allocated)
Available Bandwidth 1536 kilobits/sec
5 minute input rate 1162000 bits/sec, 188 packets/sec
5 minute output rate 1204000 bits/sec, 224 packets/sec
34551240 packets input, 1283019119 bytes, 0 no buffer
Received 29628 broadcasts, 0 runts, 0 giants, 0 throttles
1 input errors, 0 CRC, 1 frame, 0 overrun, 0 ignored, 0 abort
32940783 packets output, 2854425947 bytes, 0 underruns
0 output errors, 0 collisions, 1 interface resets
0 output buffer failures, 0 output buffers swapped out
0 carrier transitions
DCD=up DSR=up DTR=up RTS=up CTS=up
My question is why the Available is 1536 kilobit/s instead of 1984 kilobit/s? Appreciate your helps.
