"Error Message SYS-3-PORT_ERR: Port [dec]/[dec] [chars] ([dec])
Explanation This message indicates that a port error has been detected. [dec]/[dec] is the module number/port number, [chars] is the port counter name, and ([dec]) is the counter value.
Recommended Action Contact your technical support representative. "
The RxLengthErrorDrop and RxInnerCRCErrorDrop parameters relate to SNMP counters
A quick look at the 6.3 release notes shows a known bug causing RxInnerCRCErrorDrop counts:
If a duplex mismatch occurs on an ISL trunk into a Catalyst 5000 family switch, you will see swBusCRCErrorDrop errors on all ports, and you will see RxInnerCRCErrorDrop errors on ports with the duplex mismatch. This mismatch results in dropped traffic between buses.
This problem is resolved in software release 6.3(6). (CSCdw11398)"
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...