Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

There is a command on my AS5300 which I don't understand. It is

I am looking for an explanation for the command "ISDN T203 10000" on an AS5300. It was part of an ISDN d channel configuration.

1 REPLY
Anonymous
N/A

Re: There is a command on my AS5300 which I don't understand. It

Yes, the command is not documented;

I think that is partly due to the fact

that it wasn't usually configurable.

From the Q.921 spec:

Timer T203 represents the maximum time

allowed without frames being exchanged.

The default value of timer T203 shall be

10 seconds.

For the most part, you should not change

this value.

89
Views
0
Helpful
1
Replies
CreatePlease to create content